Tool Holders And Sleeves

Collet nut with chip extraction turbine applicable on tools holders HSKER32 HSKER40 EOC25 (DIN6388) and HYDRO ETP. The turbine replaces the standard collet nut or is externally applied to the HYDRO ETP spindle.

HYDRO HSK63F spindle with shaft/bore tolerance +/- 0.006. HSK63F high precision spindle and clamping force. TheTOOL shank must be with tolerance H6. Do not tighten the clamping screw if there is no tool inside. Clean the tool shank and the spindle hole thoroughly before inserting the cutter.

Tool holder HSK63F with tollerance between the tool holder and tool house 0,003 mm.

• ER32 - ER40 taper shank toolholders;
• Maximum precision and reliability;
• Total elimination of any rotation imperfections;
• Constructed from high-strength steel for superior performance;
• Precision ground on all contact surfaces;
• Fast and secure tool installation guaranteed.

Tool holder HSK63F INOX with tollerance between the tool holder and tool house 0,003 mm. Oxidation resistance.

Collet chuck ISO30 for Biesse, Omlat engine, Bulleri, Busellato, CMS, IMA, Alberti, Masterwood machines.

• ISO30 taper toolholder;
• Supplied complete with nut and drawbar (without collet);
• Maximum precision and reliability;
• Total elimination of rotation imperfections;
• HSK63F collet chuck manufactured from high-strength steel for superior performance;
• Precision ground on all contact surfaces;
• Fast and secure tool installation guaranteed.

Tool holder ISO30 to be use on Morbidelli and SCM machines.

• Manufactured from special high-strength steel;
• Supplied complete with nut and drawbar (without collet);
• Maximum precision and reliability;
• Total elimination of rotation imperfections;
• For Morbidelli and SCM machines;
• Precision ground on all contact surfaces;
• Fast and secure tool installation guaranteed.

Tool holder HSK50F with tollerance between the tool holder and tool house 0,003 mm.

Suitable for Homag, Eima from 9/94, Dubus, Weeke, Biesse, SCM, Morbidelli, Masterwood. Nut with bearing for tools with left or right rotation.

Tool Holder HSK63F of various heights with arbor different size.

Tool Holder HSK63F of various heights with arbor different size. 

Sawblade tool holder with shank for lamello clemex f22 and sawblades with hole 20/30.

Universal cone remover for HSK63F and ISO30 TOOLS HOLDERS which allows you to disassemble the TOOL HOLDER without damaging their surfaces. The special bidirectional BEARING cage, blocking the tool holder, allows the flange to be dismantled or mounted.

Replaceable standard ”ER16” collets (from 2 mm to 10 mm). Suitable for most conical chucks.

Replaceable standard ”ER20” collets (from 2 mm to 13 mm). Suitable for most conical chucks.

Replaceable standard ”ER25” collets (from 3 mm to 20 mm). Suitable for most conical chucks.

Replaceable standard ”ER32” collets (from 3 mm to 20 mm). Suitable for most conical chucks.

Replaceable high precision standard ”ER32” collets (from 3 mm to 20 mm). Suitable for most conical chucks.

Replaceable standard ”ER40” collets (from 3 mm to 25 mm). Suitable for most conical chucks.

Replaceable high precision standard ”ER40” collets (from 3 mm to 25 mm). Suitable for most conical chucks.